Collaborated with engineers to develop customized robotic solutions for specific manufacturing processes.
Process Engineer
Flex Sur
Tlajomulco de zuñiga, Jalisco
02.2016 - 02.2024
Knowledge on multiples softwares to run profiles on SMT,( add software) wave solder and selective solder.
Experience on Profiling, board profiles like design, development and any special runs (KIC & DATAPAQ)
Basic knowledge of the LPM (LOW-PRESSURE INJECTION MOLDING) process, machine setup and general mold maintenance.
Make parameter adjustments in the process of injecting the resin coating into a PCBA (electronic board).
Perform work procedures and instructions (MPI's) necessary for the equipment and implement them in the processes.
Implement process controls in the different areas where a product is manufactured.
Collaborate in the analysis of customer complaints, supporting the development of corrective and preventive action plans necessary to avoid recurrence.
Ensure compliance with Scrap, Yield, DT goals
Standardization of processes and controls for the different products in the area of PCBA.
Improve quality and process continuously.
Actively participate in audit processes to strengthen the quality system.
Make improvements in the handling of materials to avoid unnecessary use of them by optimizing processes.
Experience in SMT processes for termination of PCBs Silver immersion, Gold Immersion & OSP.
Tooling design (SMT, Ola and BackEnd).
DFM's (Design for manufacturing).
Process Technician
Jabil Circuit De México
10.2012 - 02.2016
Perform corrective and preventive maintenance on NXT machines for the component placement process.
Machine maintenance for the solder paste printing process (DEK).
Machine maintenance for the reflow oven process (HELLER)
NPI (New Product Introduction) & Prototypes for Cisco Customer.
Knowledge and Management of Phoenix X-Ray Equipment.
Reflow and Wave Process Profile Design and interpretation.
Experience in SMT processes for termination of PCBs Silver immersion, Gold Immersion & OSP.
Tooling design (SMT, Wave and Back End)
DFM's (Design for manufacturing).
Education
Bachelor of Science - Mechatronics Engineering
UTZMG (Universidad Tecnológica De La Zona Metropolitana De Guadalajara)
Tlajomulco De Zuniga, Jalisco, Mexico
01.2012
TSU (Higher University Technician) -
UTZMG (Universidad Tecnológica De Las Zona Metropolitana De Guadalajara)
Tlajomulco De Zuniga, Jalisco, Mexico
06.2008
Home
3337960312
Professionallicense
8177743
Personal Information
Date of Birth: 01/25/87
Personal Characteristics
Desire to transcend and grow personally and professionally
Team-oriented.
Rapid adaptability
Timeline
Robotic Technician
PISA
05.2024 - Current
Process Engineer
Flex Sur
02.2016 - 02.2024
Process Technician
Jabil Circuit De México
10.2012 - 02.2016
Bachelor of Science - Mechatronics Engineering
UTZMG (Universidad Tecnológica De La Zona Metropolitana De Guadalajara)
TSU (Higher University Technician) -
UTZMG (Universidad Tecnológica De Las Zona Metropolitana De Guadalajara)